SERVO TYPE 350X POWER FEED

FEATURES:

• Brushless DC motor (BLDC) provides greater efficiency and increased reliability.
• Continual monitoring of limit switches/E-Stop status, motor speed, voltage, and current using microprocessor technology.
• Produces a minimum of 350 inch/pounds of continuous torque as low as 0.3 inches/minute feed rate. This unit replaces our previous Type 140/150/200, resulting in one power feed that can be used on all three axes.
• Accurate speed regulation under varying load conditions, as well as dynamic braking for quick stops.
• Dual voltage capable with an internal connector position change on the circuit board, plus an extremely wide input voltage range (90VAC to 145VAC) and high voltage selection (195VAC to 250VAC), resulting in stable operation during power fluctuations.
• Hard-coat anodized 7075 aluminum drive gear for extreme reliability and ability to handle the high torque loads.
• The ability to easily convert the unit from a table feed to a knee feed.
• Safety E-Stop button.
• 5VDC, limit switches which is much safer in case of cable damage or cuts. No risk of electrical shock.
• Safety logic circuitry to prevent accidental operation after an emergency stop, or during power-up. The power feed will not operate after the E-Stop is released if the direction handle is either in the left or right position. The direction handle must be returned to the neutral or off position, then the status LED will turn from red to blue, letting you know you can now operate the power feed in either right or left direction.
• The RAPID button incorporates a dual-color LED that functions as a status indicator.

SERVO TYPE 350X POWER FEED - BASE UNIT